C280-16

C280-16

Cat C280-16 Marine Generator Set

Power Range 4700 - 4840 ekW
Frequency 50 / 60
Emissions EPA Tier 2, IMO II

Technicial Specifications

Power Rating
Power Range 4700 - 4840 ekW
Generator Set Specifications
Frequency 50 / 60
Speed 1000 rpm (50 hz) or 900 rpm (60 hz)
Minimum Rating 4700 ekW (5875 kVA)
Maximum Rating 4840 ekW (6050 kVA)
Engine Specifications
Emissions EPA Tier 2, IMO II
Aspiration Turbocharged-Aftercooled
Bore 280 mm
Stroke 300 mm
Displacement 296 l
Governor Type Electronic
Fuel System EUI
Compression Ratio 50 Hz 13.1
Compression Ratio 60 Hz 13:1
Engine Model Vee 16, 4-Stroke-Cycle Diesel
Generator Set Dimensions
Length 9314 mm
Width 1990 mm
Height 4167 mm
Weight 31000 kg/ 68343 lb (engine dry weight), 18145 kg/ 40000 lb (generator weight)

Advantages and Features

A3 ECU

Advantages

CAN J1939 data link Waterproof connectors, Maintenance-free, Backup ECU for redundant governing

Electronic Advantages

Load feedback, Programmable droop, Adjustable gain, Adjustable fuel/air ratio control, Histograms of engine operation, Cat Messenger display presents diagnostics and other engine parameters

Data Advantages through J1939 Link

Engine speed, Boost pressure, Throttle position, Fuel consumption rate, Inlet manifold temperature, Diagnostic codes and events, Configuration, Desired engine speed, Battery voltage, Engine load, Lifetime totals — engine hours, fuel burned, idle fuel, idle hours, Trip totals — average fuel rate, idle fuel, idle hours, engine hours, fuel burned, trip reset

Customer Interface Panel

Advantages

Interfaces with standard Cat® Marine Monitoring System (PLC in Price List) Provides visual indication of ECU functionality, Accepts 4 — 20 mA or PWM remote throttle speed input, Marine alarm and protection

Electronic Unit Injectors

Advantages

“Drop-in” installation, No threaded fuel connections, High pressure inside injector only, Does not require double wall fuel lines or leak collection device, Injector synchronization not required

Standard Equipment

  • Air Inlet System
    • Aftercooler — fresh water, corrosion resistant coated (air side); air inlet shutoff; breather — crankcase, top-mounted; turbocharger — engine oil lubricated
  • Control System
    • Single Caterpillar® A3 electronic control unit (ECU) with electronic unit injector fuel system, rigid wiring harness (10 amp, 24 volt power required to drive ECUs)
  • Cooling System
    • Engine coolant water drains
  • Exhaust System
    • Dry, gas tight, exhaust manifold
  • Fuel System
    • Distillate fuel (requires viscosity ranging from 1.4 cSt to 20 cSt at 38° C), fuel transfer pump (mounted on left-hand side), duplex fuel filters, electronically controlled unit injectors
  • Lube Oil System
    • Centrifugal oil filters with single shutoff, service side engine mounted on cylinder block inspection covers includes installed oil lines and single shutoff valve, filters centrifuge bypass oil from the main lubricating oil pump, can be serviced with the engine running, oil filler and dipstick valve, oil pressure regulating valves, crankcase explosion relief valves
  • General
    • Caterpillar yellow paint; gear-driven pumps: fuel, oil, jacket water, aftercooler/oil cooler water; service literature